ГЕНЕРАТОР СНЯТИЕ

  1. REMOVE RADIATOR SUPPORT OPENING COVER

    1. Remove the 7 clips and radiator support opening cover.

      A00OKW2

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR ENGINE UNDER COVER RH

    1. Снимите 5 фиксаторов и правую защиту картера.

      A00OMDF

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    1. A010LIT

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  6. REMOVE V-RIBBED BELT

    1. Ослабьте болты A и В.

      A00OILIE01

    2. Ослабьте болт C и снимите поликлиновой ремень.

      Note

      Не ослабляйте болт D.

  7. REMOVE GENERATOR ASSEMBLY

    1. Remove the terminal cap.

      A00ONWT

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the connector and detach the wire harness clamp.

    4. Remove the 2 bolts and adjusting bar.

      A00OK6FE01

    5. Remove the bolt and generator.

      A00OKGNE01

    6. Remove the bolt and wire harness clamp bracket.

      A00OJ9U