СИСТЕМА АВТОМАТИЧЕСКОЙ ТРАНСМИССИИ (для моделей с 1AZ-FE) ИНИЦИАЛИЗАЦИЯ ЭЛЕКТРОННОЙ СИСТЕМЫ

  1. RESET MEMORY

    Note

    • Perform the Reset Memory procedures (A/T initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.

    • Reset Memory can only be performed with the intelligent tester.

    Tech Tips

    The ECM memorizes the vehicle conditions when the ECT controls the automatic transaxle assembly and engine assembly. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.

    The reset procedures are as follows.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Utility / Reset Memory. Then, press "NEXT".

    5. Perform the Reset Memory procedures from the main menu.

      CAUTION:

      After performing Reset Memory, be sure to perform the Road Test Click here described earlier.

      Tech Tips

      The ECM learns through the Road Test.