ВЫКЛЮЧАТЕЛЬ ЗАЖИГАНИЯ ПРОВЕРКА

  1. INSPECT ENGINE SWITCH

    A00DR7VE04

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Position Specified Condition
      7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher
      2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher
      7 (SS1) - 5 (GND) Pushed 15 Ω
      2 (SS2) - 5 (GND) Pushed 15 Ω

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage to the terminals of the switch and check the illumination condition of the switch.

      Tech Tips

      • If the positive (+) lead and negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

      • If the voltage is too low, the indicator light will not illuminate.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 11 (SWIL)

      Battery negative (-) → Terminal 4 (COM) or 5 (GND)

      Illuminates

      (illumination of lettering)

      Battery positive (+) → Terminal 12 (INDS)

      Battery negative (-) → Terminal 4 (COM) or 5 (GND)

      Illuminates

      (green)

      Battery positive (+) → Terminal 13 (INDW)

      Battery negative (-) → Terminal 4 (COM) or 5 (GND)

      Illuminates

      (amber)
      A00DQIEE50

      If the result is not as specified, replace the engine switch.