ГОЛОВКА БЛОКА ЦИЛИНДРОВ ПОВТОРНАЯ СБОРКА

  1. INSTALL STUD BOLT

    Note

    If a stud bolt is deformed or its threads are damaged, replace it.

    A00DT3AE07

    1. Using an E8 "TORX" socket wrench, install the stud bolts.

      Torque:
      9.5 N*m  { 97 kgf*cm, 84 in.*lbf }

  2. INSTALL NO. 2 STRAIGHT SCREW PLUG

    Note

    If water leaks from the straight screw plug or the plug is corroded, replace it.

    A00DTWC

    1. Using a 10 mm straight hexagon wrench, install 3 new gaskets and the 3 straight screw plugs.

      Torque:
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

  3. INSTALL VALVE SPRING SEAT

    1. Install the valve spring seats to the cylinder head.

  4. INSTALL VALVE STEM OIL SEAL

    1. Apply a light coat of engine oil to a new oil seal.

      A00DUE7E02

      Note

      Pay close attention when installing the intake and exhaust oil seals. For example, installing the intake oil seal to the exhaust side or installing the exhaust oil seal to the intake side can cause installation problems later.

      Tech Tips

      The intake valve oil seal is gray and the exhaust valve oil seal is black.

    2. Using SST, push on the oil seal.

      A00DSCME01
      SST
      09201-41020

      Note

      Failure to use SST will cause the seal to be damaged or improperly seated.

  5. INSTALL INTAKE VALVE

    1. Place the cylinder head on wooden blocks.

    2. Apply engine oil to each valve over an area 30 mm (1.18 in.) or more from its tip, as shown in the illustration.

      A00DRF6E15

    3. Install the valve, compression spring and spring retainer to the cylinder head.

      Note

      Install the same parts in the same combination to the original locations.

    4. Using SST and wooden blocks, compress the spring and install the 2 retainer locks.

      A00DPIHE02
      SST
      09202-70020   ( 09202-00010 )

    5. Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.

      A00DPUJ

      Note

      • Be careful not to damage the valve stem tip.

      • Be careful not to damage the retainer.

  6. INSTALL EXHAUST VALVE

    1. Place the cylinder head on wooden blocks.

    2. Apply engine oil to each valve over an area 30 mm (1.18 in.) or more from its tip, as shown in the illustration.

      A00DTHFE14

    3. Install the valve, compression spring and spring retainer to the cylinder head.

      Note

      Install the same parts in the same combination to the original locations.

    4. Using SST and wooden blocks, compress the spring and install the 2 retainer locks.

      A00DR9NE02
      SST
      09202-70020   ( 09202-00010 )

    5. Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.

      A00DQZY

      Note

      • Be careful not to damage the valve stem tip.

      • Be careful not to damage the retainer.