ГОЛОВКА БЛОКА ЦИЛИНДРОВ РАЗБОРКА

  1. REMOVE INTAKE VALVE

    1. Place the cylinder head on wooden blocks.

      A00DPIHE02

    2. Using SST, compress the compression spring and remove the valve retainer locks.

      SST
      09202-70020   ( 09202-00010 )

      Tech Tips

      Arrange the removed parts in the correct order.

    3. Remove the retainer, compression spring and valve.

      Tech Tips

      Arrange the removed parts in the correct order.

  2. REMOVE EXHAUST VALVE

    1. Place the cylinder head on wooden blocks.

    2. Using SST, compress the compression spring and remove the valve retainer locks.

      A00DR9NE02
      SST
      09202-70020   ( 09202-00010 )

      Tech Tips

      Arrange the removed parts in the correct order.

    3. Remove the retainer, compression spring and valve.

      Tech Tips

      Arrange the removed parts in the correct order.

  3. REMOVE VALVE STEM OIL SEAL

    1. Using needle-nose pliers, remove the oil seals.

      A00DURI

  4. REMOVE VALVE SPRING SEAT

    1. Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.

      A00DTWZ

  5. REMOVE NO. 2 STRAIGHT SCREW PLUG

    Note

    If water leaks from the straight screw plug or the plug in corroded, replace it.

    A00DTWC

    1. Using a 10 mm straight hexagon wrench, remove the 3 screw plugs and 3 gaskets.

  6. REMOVE STUD BOLT

    Note

    If a stud bolt is deformed or its threads are damaged, replace it.