ТОПЛИВНЫЙ НАСОС РАЗБОРКА

  1. REMOVE FUEL SENDER GAUGE ASSEMBLY

    1. A005RND

      Disconnect the connector of the fuel sender gauge assembly.

    2. Remove the harness protector from the wire harness.

    3. Disconnect the 2 harness clamps.

      Note

      Do not damage the wire harness.

    4. A005S68

      Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.

  2. REMOVE FUEL PUMP

    Note

    Do not separate the tube indicated in the illustration Click here.

    1. Disconnect the fuel pump filter hose.

      A005RWQ

    2. Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the fuel filter and fuel pump from the fuel sub-tank.

      A005WBF

    3. Using needle-nose pliers, detach the 2 claws and remove the No. 1 fuel suction support.

      A005RXM

    4. Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.

      A005R7A

      Note

      • Do not damage the fuel pump filter.

      • Do not remove the suction filter.

      • Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.

    5. Disconnect the fuel pump harness connector.

      A005SQI

    6. Remove the O-ring from the fuel filter.

      A005W31E01

    7. Remove the fuel pump spacer from the fuel pump assembly.

      Text in Illustration
      *1 O-Ring
      *2 Fuel Pump Spacer