ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

  1. INSTALL ENGINE REAR OIL SEAL

    1. Apply MP grease to the lip of a new oil seal.

      A00OLEQE02

      Note

      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note

      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

    1. Using SST, hold the crankshaft.

      A00OILJE01
      SST
      09330-00021
      09213-58014   ( 91551-80840 )

    2. Install the front spacer, drive plate and rear spacer onto the crankshaft.

      A00OJ8VE01

    3. Clean the bolts and bolt holes.

      A00OKOTE03

    4. Apply adhesive to 2 or 3 threads at the end of the 8 bolts.

      Text in Illustration
      *1 Adhesive
      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    5. Install the front spacer, drive plate and rear spacer with the 8 bolts. Uniformly tighten the 8 bolts.

      A00OIVR
      Torque:
      88 N*m  { 897 kgf*cm, 65 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    1. Install the automatic transaxle assembly Click here.

  4. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

    1. Install the engine assembly with transaxle Click here.