ECM УСТАНОВКА

  1. INSTALL ECM

    1. Install the No. 1 ECM bracket and No. 2 ECM bracket to the ECM with the 4 screws.

      A00DRXH
      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

    2. Install the ECM with the 2 bolts.

      A00DU5R
      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

    3. Connect the 2 ECM connectors.

      1. Connect the 2 ECM connectors and lower the 2 levers.

        A00DTQV

        Note

        • When connecting the connectors, make sure that dirt, water or other foreign matter does not get caught between the connectors and other parts.

        • Make sure that the 2 levers are securely lowered.

    4. A00DS11

      Connect the wire harness clamp.

  2. CONNECT NO. 2 AIR CLEANER INLET

    1. A00DRVI

      Connect the No. 2 air cleaner inlet to the vehicle body with the bolt.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

  3. INSTALL NO. 1 AIR CLEANER INLET

    1. A00DUX8

      Attach the 2 claws to install the No. 1 air cleaner inlet.

    2. Install the clip.

  4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    1. A00DQ1D

      Install the air cleaner case with the 3 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Attach the wire harness clamp to the air cleaner case.

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    1. Подсоедините крышку воздушного фильтра с помощью хомута.

      A005W5Q

    2. Подключите вентиляционный шланг.

    3. Подсоедините 2 зажима.

      A005U5E
    4. A005UEV

      Закрепите жгут проводов с помощью 2 зажимов.

    5. Подключите разъем датчика массового расхода воздуха.

  6. INSTALL NO. 2 CYLINDER HEAD COVER

    1. A005VFG

      Установите крышку и введите в зацепление 4 фиксатора.

      Note

      • Проверьте надежность зацепления фиксаторов.

      • Во время зацепления фиксаторов на крышке не прикладывайте чрезмерных усилий и не допускайте ударов. Это может привести к поломке крышки.

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. INSTALL RADIATOR SUPPORT OPENING COVER

    1. Install the radiator support opening cover with the 8 clips.

      A00DRS1

  9. INSTALL ENGINE ROOM SIDE COVER

    1. Install the engine room side cover with the clip.

      A00DRIG

  10. RESET MEMORY

    1. When replacing the ECM, perform the Reset Memory procedure (A/T initialization) Click here.