REMOVE ENGINE ROOM SIDE COVER
Remove the clip and engine room side cover.
REMOVE RADIATOR SUPPORT OPENING COVER
Remove the 8 clips and radiator support opening cover.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE NO. 2 CYLINDER HEAD COVER
Возьмитесь сзади за крышку и поднимите ее, чтобы разъединить 2 задних фиксатора крышки. Продолжайте поднимать крышку так, чтобы освободить 2 передних фиксатора крышки, после чего снимите крышку.
Note
Попытка освободить задние и передние фиксаторы за один прием может привести к поломке крышки.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
Отсоедините разъем датчика массового расхода воздуха.
Отсоедините жгут проводов от 2 зажимов.
Отсоедините 2 зажима.
Отсоедините шланг вентиляции.
Ослабьте хомут и снимите крышку воздушного фильтра.
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Detach the wire harness clamp from the air cleaner case.
Remove the 3 bolts and air cleaner case.
REMOVE NO. 1 AIR CLEANER INLET
Remove the clip.
Detach the 2 claws and remove the No. 1 air cleaner inlet.
DISCONNECT NO. 2 AIR CLEANER INLET
Remove the bolt and disconnect the No. 2 air cleaner inlet from the vehicle body.
REMOVE ECM
Disconnect the wire harness clamp.
Disconnect the 2 ECM connectors.
Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.
Note
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
Remove the 2 bolts and ECM.
Remove the 4 screws, No. 1 ECM bracket and No. 2 ECM bracket.