АВТОМАТИЧЕСКАЯ ТРАНСМИССИЯ В СБОРЕ (для моделей с 3ZR-FE) СНЯТИЕ

  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    1. Remove the engine with transaxle Click here.

  2. REMOVE STARTER ASSEMBLY

    1. Отсоедините крышку контакта.

      A005RHO
    2. Отверните гайку и отсоедините провод стартера.

    3. Отсоедините разъем.

    4. Выверните 2 болта и снимите стартер.

  3. DISCONNECT WIRE HARNESS

    A005TCE
    1. Disconnect the park/neutral position switch connector.

    2. Disconnect the transaxle wire connector.

    3. Disconnect the 2 speed sensor connectors.

    4. Detach the 4 wire harness clamps.

  4. REMOVE GROUND CABLE

    1. Remove the bolt and detach the clamp, and remove the ground cable.

  5. REMOVE FRONT ENGINE MOUNTING BRACKET

    A005WII
    1. Remove the 3 bolts and mounting bracket.

  6. REMOVE REAR ENGINE MOUNTING BRACKET

    A005WLP
    1. Remove the 3 bolts and mounting bracket.

  7. REMOVE ENGINE MOUNTING BRACKET LH

    A005SOI
    1. Remove the 3 bolts and mounting bracket.

  8. REMOVE OIL COOLER TUBE SUB-ASSEMBLY

    A005RCQE01
    1. Disconnect the 2 oil cooler hoses.

    2. Remove the bolt and oil cooler tube.

  9. REMOVE DRIVE PLATE AND TORQUE CONVERTER SETTING BOLT

    A005VCFE01
    1. Remove the flywheel housing under cover.

    2. Turn the crankshaft to gain access to the 6 bolts and remove each bolt while holding the crankshaft pulley bolt with a wrench.

  10. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

    A005UYW
    1. Remove the 3 bolts.

    2. Remove the 5 lower side mounting bolts.

      A005UMU
    3. Remove the automatic transaxle.

  11. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

    A005VHN
    1. Remove the ATF dipstick.

    2. Remove the bolt and oil filler tube.

    3. Remove the O-ring from the transmission oil filler tube.

  12. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

    A005UZU
    1. Remove the 2 bolts and No. 1 transmission control cable bracket.

  13. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY

    A005TT1
    1. Remove the bolt and hole cover from the transaxle case.

    2. Remove the O-ring from the hole cover.

  14. REMOVE WIRE HARNESS CLAMP BRACKET

    A005V5H
    1. Remove the bolt and wire harness clamp bracket.

  15. REMOVE TRANSMISSION CONTROL CABLE SUPPORT

    A005UBR
    1. Remove the bolt and transmission control cable support.

  16. REMOVE TORQUE CONVERTER ASSEMBLY