РЫЧАГ ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ РЕГУЛИРОВКА

  1. INSPECT SHIFT LEVER POSITION

    1. When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

    2. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R. If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

  2. ADJUST SHIFT LEVER POSITION

    1. Remove the console box assembly Click here.

    2. Apply the parking brake and move the shift lever to N.

    3. Disconnect the end of the transmission control cable assembly from the shift lever assembly.

      A005V6LE01

    4. Pull out the stopper of the transmission control cable.

      A005T1IE01
      Text in Illustration
      *1 Stopper
      *2 Nut

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    5. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

    6. Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.

      A005VHLE01

    7. Turn the nut of the transmission control cable 180° counterclockwise. While holding the nut in place, push in the stopper until the stopper clicks twice.

      A005VB6E01
      Text in Illustration
      *1 Stopper *2 Nut

    8. Install the outer part of the transmission control cable to the shift lever retainer. Check that the spring is positioned at "A" and push in the stopper.

      A005SG3E01
      Text in Illustration
      *1 Stopper *3 Shift Lever Retainer
      *2 Nut *4 Spring

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    9. Connect the end of the cable to the shift lever assembly.

      A005VIFE01

      Note

      • Make sure that the lock piece is pulled up.

      • Push on the end of the cable all the way to the base of the pin.

      Text in Illustration
      *1 Lock Piece

    10. Push the lock piece into the adjuster case.

      A005VBXE01
      Text in Illustration
      *1 Lock Piece
      *2 Adjuster Case

      Note

      Securely push in the lock piece until it locks.

    11. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.

    12. Install the console box Click here.