ДАТЧИК ПОЛОЖЕНИЯ ПАРКИНГА / НЕЙТРАЛИ СНЯТИЕ

  1. REMOVE ENGINE ROOM SIDE COVER

    A005RE1

    1. Using a clip remover, remove the clip and engine room side cover.

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    A005SU5

    1. Using a clip remover, remove the 8 clips and radiator support opening cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE BATTERY

    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  5. REMOVE BATTERY CARRIER

    A005RI3

    1. Detach the 2 wire harness clamps.

    2. Remove the 4 bolts and battery carrier.

  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    A005V8N

    1. Remove the nut and disconnect the control cable from the control shaft lever.

  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    A005US7

    1. Disconnect the park/neutral position switch connector.

    2. Remove the nut, washer and control shaft lever.

      A005SRK

    3. Using a screwdriver, bend the tabs of the lock plate.

      A005W0N

    4. Remove the lock nut and lock plate.

    5. Remove the 2 bolts and pull out the park/neutral position switch to remove it.

      A005TVM