КОРПУС КЛАПАНОВ В СБОРЕ СНЯТИЕ

REMOVE ENGINE ROOM SIDE COVER

1. Using a clip remover, remove the clip and engine room side cover.

REMOVE RADIATOR SUPPORT OPENING COVER

1. Using a clip remover, remove the 8 clips and radiator support opening cover.

REMOVE FRONT LOWER BUMPER ABSORBER

1. Remove the 2 screws and 4 bolts.

2. Remove the 3 screws, 8 bolts and front lower bumper absorber.

   

REMOVE NO. 1 ENGINE UNDER COVER (for 1AZ-FE)

1. 

   Снимите 5 фиксаторов и защиту картера.

REMOVE NO. 1 ENGINE UNDER COVER (for 3ZR-FE)

1. Снимите 10 фиксаторов и защиту картера.

   

DRAIN AUTOMATIC TRANSAXLE FLUID

1. Remove the drain plug and gasket, and drain the ATF.

2. Install a new gasket and the drain plug.

   Torque:

   49 N*m  { 500 kgf*cm, 36 ft.*lbf }

REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

1. Remove the 18 bolts, oil pan and gasket.

   Note

   Some fluid will remain in the oil pan. Carefully remove the oil pan.

2. Remove the 2 magnets from the oil pan.

3. Examine particles in the pan.

   

   1. Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to anticipate what type of wear you will find in the transaxle.

      Steel (magnetic): bearing, gear and plate wear

      Brass (non-magnetic): bush wear

DISCONNECT TRANSMISSION WIRE

1. Disconnect the 5 shift solenoid valve connectors.

2. Remove the bolt, lock plate and ATF temperature sensor.

   Text in Illustration

   *1	Lock Plate