ЖГУТ ЭЛЕКТРОПРОВОДКИ ТРАНСМИССИИ СНЯТИЕ

  1. REMOVE ENGINE ROOM SIDE COVER

    A005RE1

    1. Using a clip remover, remove the clip and engine room side cover.

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    A005SU5

    1. Using a clip remover, remove the 8 clips and radiator support opening cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE BATTERY

    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  5. REMOVE BATTERY CARRIER

    A005RI3

    1. Detach the 2 wire harness clamps.

    2. Remove the 4 bolts and battery carrier.

  6. REMOVE FRONT LOWER BUMPER ABSORBER

    A00DUZW

    1. Remove the 2 screws and 4 bolts.

    2. Remove the 3 screws, 8 bolts and front lower bumper absorber.

      A00DTLK

  7. REMOVE NO. 1 ENGINE UNDER COVER (for 1AZ-FE)

    1. A005VAK

      Снимите 5 фиксаторов и защиту картера.

  8. REMOVE NO. 1 ENGINE UNDER COVER (for 3ZR-FE)

    1. Снимите 10 фиксаторов и защиту картера.

      A00ON3U

  9. DRAIN AUTOMATIC TRANSAXLE FLUID

    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

  10. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

    A00DRR3E01

    1. Remove the 18 bolts, oil pan and gasket.

      Note

      Some fluid will remain in the oil pan. Carefully remove the oil pan.

    2. Remove the 2 magnets from the oil pan.

    3. Examine particles in the pan.

      A00DS3SE01

      1. Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to anticipate what type of wear you will find in the transaxle.

        Steel (magnetic): bearing, gear and plate wear

        Brass (non-magnetic): bush wear

  11. DISCONNECT TRANSMISSION WIRE

    A00DRNRE08

    1. Disconnect the 5 shift solenoid valve connectors.

    2. Remove the bolt, lock plate and ATF temperature sensor.

      Text in Illustration
      *1 Lock Plate

  12. REMOVE TRANSMISSION WIRE

    A00DTI2

    1. Disconnect the transmission wire connector.

    2. Remove the bolt and transmission wire.

    3. Remove the O-ring from the transmission wire.

      A00DUVUE02