МАСЛЯНЫЙ РАДИАТОР СНЯТИЕ

  1. REMOVE RADIATOR SUPPORT OPENING COVER

    1. Remove the 7 clips and radiator support opening cover.

      A00OKW2

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE BATTERY

    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  5. REMOVE BATTERY CARRIER

    A00OJKB

    1. Detach the 2 wire harness clamps.

    2. Remove the 4 bolts and battery carrier.

  6. REMOVE FRONT LOWER BUMPER ABSORBER

    A00OL3A

    1. Remove the 2 screws and 4 bolts.

    2. Remove the 3 screws, 8 bolts and front lower bumper absorber.

      A00OI9A

  7. REMOVE NO. 1 ENGINE UNDER COVER

    1. Снимите 10 фиксаторов и защиту картера.

      A00ON3U

  8. REMOVE NO. 1 OIL COOLER TUBE SUB-ASSEMBLY

    A00ONUQ

    1. Disconnect the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose from the No. 2 oil cooler tube sub-assembly.

    2. Disconnect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the automatic transaxle.

      A00OHS9

    3. Remove the bolt and No. 1 oil cooler tube sub-assembly.

    4. Remove the No. 1 oil cooler inlet hose, No. 1 oil cooler outlet hose, No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose.

      A00ONCD

  9. REMOVE NO. 2 OIL COOLER TUBE SUB-ASSEMBLY

    1. Disconnect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose from the radiator.

      A00ON1H

    2. Disconnect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose.

    3. Remove the 2 bolts and No. 2 oil cooler tube sub-assembly.