МАСЛЯНЫЙ РАДИАТОР СНЯТИЕ

  1. REMOVE ENGINE ROOM SIDE COVER

    A005RE1

    1. Using a clip remover, remove the clip and engine room side cover.

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    A005SU5

    1. Using a clip remover, remove the 8 clips and radiator support opening cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE BATTERY

    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  5. REMOVE BATTERY CARRIER

    A005RI3

    1. Detach the 2 wire harness clamps.

    2. Remove the 4 bolts and battery carrier.

  6. REMOVE FRONT LOWER BUMPER ABSORBER

    A00DUZW

    1. Remove the 2 screws and 4 bolts.

    2. Remove the 3 screws, 8 bolts and front lower bumper absorber.

      A00DTLK

  7. REMOVE NO. 1 ENGINE UNDER COVER (for 1AZ-FE)

    1. A005VAK

      Снимите 5 фиксаторов и защиту картера.

  8. REMOVE NO. 1 ENGINE UNDER COVER (for 3ZR-FE)

    1. Снимите 10 фиксаторов и защиту картера.

      A00ON3U

  9. REMOVE NO. 1 OIL COOLER TUBE SUB-ASSEMBLY

    A005VOQE01

    1. Disconnect the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose from the No. 2 oil cooler tube sub-assembly.

    2. Disconnect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the automatic transaxle.

      A005RODE01

    3. Remove the bolt and No. 1 oil cooler tube sub-assembly.

    4. Remove the No. 1 oil cooler inlet hose, No. 1 oil cooler outlet hose, No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose.

      A005UI8E01

  10. REMOVE NO. 2 OIL COOLER TUBE SUB-ASSEMBLY

    1. Disconnect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose from the radiator.

      A005WBNE01

    2. for 1AZ-FE:

      Detach the cooler hose clamp from the radiator.

    3. Disconnect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose.

    4. Remove the 2 bolts and No. 2 oil cooler tube sub-assembly.