ROCKER PANEL MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT REAR WHEEL HOUSE PLATE

    Click here

  2. REMOVE ROCKER PANEL MOULDING ASSEMBLY


    1. Apply protective tape around the rocker panel moulding assembly and door as shown in the illustration.

      A01F85YC01
      B0076EM Protective Tape - -
    2. A01FAJX

      Remove the 2 screws.

    3. Using a clip remover, remove the clip.

    4. A01F8A2

      Remove the screw.

    5. A01F8C9C01
      B0076EM Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the rocker panel moulding cover.

      Tech Tips

      Use the same procedure for the other rocker panel moulding cover.

    6. A01F9GU

      Using a clip remover, remove the 6 clips.

    7. Remove the 2 screws.

    8. A01FAN3

      Disengage the 10 clips and remove the rocker panel moulding assembly.

    9. Remove the 10 clips from the rocker panel moulding assembly.