HEADLIGHT LEVELING ECU REMOVAL

PROCEDURE


  1. PRECAUTION (w/ AVS)

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ AVS)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  4. REMOVE FRONT NO. 1 CONSOLE BOX INSERT

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  6. REMOVE FRONT DOOR OPENING TRIM COVER LH

    Click here

  7. REMOVE ACCELERATOR PEDAL PAD (for LHD)

    Click here

  8. REMOVE ACCELERATOR PEDAL ASSEMBLY (for LHD)

    Click here

  9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  10. REMOVE ACCELERATION SENSOR (w/ AVS)

    Click here

  11. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY


    1. B0076BU

      Disengage the 2 claws to separate the front floor carpet assembly from the 2 floor carpet hooks.

    2. for LHD:


      1. B0073KAC01
        B0076EM Fastener

        Using a clip remover, remove the clip.

      2. Disengage the clamp.

      3. Disengage each fastener and turn back the front floor carpet assembly as shown in the illustration.

    3. for RHD:


      1. B007468C01
        B0076EM Fastener

        Disengage the clamp.

      2. Disengage the fastener and turn back the front floor carpet assembly as shown in the illustration.

    4. for LHD:


      1. B00748B

        Disengage the 2 clamps to remove the No. 3 dash panel insulator pad.

    5. for RHD:


      1. B0073N4C01
        B0076EM Fastener

        Disengage the fastener to remove the No. 3 dash panel insulator pad.

    6. B0076ZT

      Remove the bolt to disconnect the earth wire.

    7. Using a clip remover, disengage the 3 clips to disconnect the connector holder.

    8. B0075L0C01
      *a Clamp
      *b Guide
      B0077IM Nut
      B0077LI Bolt

      Disconnect the connector.

    9. Disengage the clamp.

    10. Remove the nut and bolt.

    11. Disengage the guide to remove the headlight leveling ECU assembly.