HEIGHT CONTROL SENSOR INSTALLATION

PROCEDURE

1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

   
   

   1. Install the rear height control sensor sub-assembly with the 2 bolts and nut.

      Torque:

      Bolt

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Nut

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   2. Engage the clamp.

   3. Connect the connector.

2. INSTALL REAR WHEEL LH

   Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL (for Single Beam Headlight)

   Click here

5. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL (for Triple Beam Headlight)

   Click here

6. ADJUST HEADLIGHT AIMING (for Single Beam Headlight)

   Click here

7. ADJUST HEADLIGHT AIMING (for Triple Beam Headlight)

   Click here