LIGHTING SYSTEM(for Triple Beam Headlight), Diagnostic DTC:B242E

DTC Code DTC Name
B242E Open in IG Circuit

DESCRIPTION

This DTC is stored when a malfunction occurs in the headlight light control ECU sub-assembly RH IG power source circuit. The headlight light control ECU sub-assembly LH stores DTC B242E.

DTC No. Detection Item DTC Detection Condition Trouble Area
B242E Open in IG Circuit Open in the headlight light control ECU sub-assembly RH IG power source circuit
  • Headlight light control ECU sub-assembly RH

  • Harness or connector

WIRING DIAGRAM

B0075X3E04
*a from IG1 NO. 3 Relay
*b ECU-IG1 NO. 2
*c Headlight light control ECU sub-assembly RH

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT
  2. CHECK FOR DTC


    1. Turn the engine switch on (IG).

    2. Check for DTCs.

      Click here


      Body Electrical > HL AutoLeveling > Trouble Codes
      OK
      DTC B242E is not output.
      Result
      Proceed to
      OK
      NG

    OK
    NG
  3. CHECK HARNESS AND CONNECTOR (HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH - BATTERY AND BODY GROUND)


    1. Disconnect the A7 headlight light control ECU sub-assembly RH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A7-4 (IG) - Body ground Engine switch off Below 1 V
      A7-4 (IG) - Body ground Engine switch on (IG) 11 to 14 V
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A7-12 (GND) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK
    NG