RELAY ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT WIPER RELAY

   
   
   1. 

      *a	Component without harness connected (WIPER Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 - 4 Battery voltage not applied between terminals 1 and 2 Below 1 Ω Battery voltage applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the WIPER relay.

2. INSPECT INT RELAY

   
   
   1. 

      *a	Component without harness connected (INT Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 - 4 Battery voltage not applied between terminals 1 and 2 Below 1 Ω Battery voltage applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the INT relay.