OUTER REAR VIEW MIRROR GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR


    1. A01FARFC01
      B0076EM Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface to tilt the outer mirror.

    3. Using a moulding remover, disengage the 2 claws on the lower part of the outer mirror as shown in the illustration.

    4. A01FASCC01
      B0076EM Protective Tape

      Apply protective tape to the area shown in the illustration.

    5. Push the lower part of the mirror surface to tilt the outer mirror.

    6. Using a moulding remover, disengage the 2 claws on the upper part of the outer mirror as shown in the illustration.

    7. w/ Mirror Heater:


      1. A01F89A

        Disengage the clamp.

      2. Disconnect the 2 mirror heater connectors.

    8. w/ EC Mirror:


      1. A01FBHS

        Disengage the 3 clamps.

      2. Release the tabs of the EC mirror connector and disconnect the EC mirror connector.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror with a new one.

    9. w/ Blind Spot Monitor System:


      1. A01F71L

        Disengage the 3 clamps.

      2. Release the tabs of the blind spot monitor indicator connector and disconnect the blind spot monitor indicator connector.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror actuator assembly with a new one.

    10. Remove the outer mirror.