OUTER REAR VIEW MIRROR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  6. REMOVE DOOR TRIM COVER

    Click here

  7. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  8. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  10. REMOVE OUTER MIRROR PROTECTOR


    1. B0072UN

      Disconnect the connector.

    2. Disengage the clamp.

    3. B0072PQN01

      Remove the screw.

    4. Disengage the 2 claws and remove the outer mirror protector.

      Tech Tips

      Disengage the claws in the order shown in the illustration.

  11. REMOVE OUTER MIRROR INSTALL HOLE COVER


    1. B00747W

      Remove the outer mirror install hole cover.

  12. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


    1. B0074EZ

      Disengage the clamp.

    2. Remove the 3 nuts.

    3. B00769W

      Disengage the claw and 2 guides to remove the outer rear view mirror assembly.