HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

   
   

   1. Tie the string that was passed through the engine compartment to the end of the hood lock control cable assembly.

   2. for LHD:

      
      
      1. 

         *1	Hood Lock Control Cable Assembly
         *a	Grommet

         Pass the hood lock control cable assembly through the grommet as shown in the illustration.

   3. for RHD:

      
      
      1. 

         *1	Hood Lock Control Cable Assembly
         *a	Grommet

         Pass the hood lock control cable assembly through the grommet as shown in the illustration.

   4. Disconnect the string from the hood lock control cable assembly.

   5. Pass the hood lock control cable assembly through the upper radiator support.

   6. Engage the 4 clamps and install the hood lock control cable assembly.

2. INSTALL HOOD LOCK ASSEMBLY

   
   

   1. 

      Apply MP grease to the sliding areas of the lock.

   2. Connect the hood lock control cable assembly.

   3. 

      Install the hood lock assembly with the 3 bolts.

      Torque:

      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

   4. Connect the connector.

3. INSTALL HOOD LOCK RELEASE LEVER PROTECTOR

   
   

   1. Engage the clamp.

   2. Install the hood lock release lever protector with the 2 clips.

   3. Engage the 2 clamps.

4. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   
   

   1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

5. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

7. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

   Click here

8. INSTALL COOL AIR INTAKE DUCT SEAL

   Click here

9. INSTALL ENGINE ROOM SIDE COVER

   See page XXX

   Click here

10. ADJUST HOOD SUB-ASSEMBLY

    Click here