HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

PROCEDURE


  1. REMOVE ENGINE ROOM SIDE COVER

    Click here

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  6. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. B0072M8

      Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.

  7. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR


    1. A01R3O6

      Disengage the 2 clamps.

    2. A01R6DE

      Remove the 2 clips.

    3. Disengage the clamp to remove the hood lock release lever protector.

  8. REMOVE HOOD LOCK ASSEMBLY


    1. B0072QW

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. for LHD:


      1. B00754W

        Disconnect the hood lock control cable assembly to remove the hood lock assembly.

    4. for RHD:


      1. B0072LR

        Disconnect the hood lock control cable assembly to remove the hood lock assembly.

  9. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. B0076P5

      Tie a string to the end of the hood lock control cable assembly.

      Tech Tips

      Use a length of string long enough to pass through the engine compartment.

    2. B00764GC01
      *1 Hood Lock Control Cable Assembly
      *a Grommet

      Pull out the hood lock control cable assembly through the grommet as shown in the illustration.

      Tech Tips

      Leave the string inside the grommet.

    3. Disconnect the string from the hood lock control cable assembly.

    4. Using a screwdriver, disengage the 4 clamps.

      B0072TKC01
      *1 Hood Lock Control Cable Assembly - -
      *a Clamp - -

      Tech Tips

      Tape the screwdriver tip before use.

    5. Pull the hood lock control cable assembly from the engine compartment to remove it.

  10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. B0076P5

      Tie a string to the end of the hood lock control cable assembly.

      Tech Tips

      Use a length of string long enough to pass through the engine compartment.

    2. B0076S2C01
      *1 Hood Lock Control Cable Assembly
      *a Grommet

      Pull out the hood lock control cable assembly through the grommet as shown in the illustration.

      Tech Tips

      Leave the string inside the grommet.

    3. Disconnect the string from the hood lock control cable assembly.

    4. Using a screwdriver, disengage the 4 clamps.

      B0076XZC01
      *1 Hood Lock Control Cable Assembly - -
      *a Clamp - -

      Tech Tips

      Tape the screwdriver tip before use.

    5. Pull the hood lock control cable assembly from the engine compartment to remove it.