POWER WINDOW CONTROL SYSTEM Front Passenger Side Door-linked Window Control does not Operate

DESCRIPTION

The main body ECU (multiplex network body ECU) detects signals from the front door courtesy light switch assembly. When the ON signal from the front door courtesy light switch assembly is sent to the power window regulator switch assembly via the main body ECU (multiplex network body ECU) using LIN communication system, the main body ECU (multiplex network body ECU) will lower the front passenger side door window about 12 mm (0.472 in.) automatically. When the OFF signal from the front door courtesy light switch assembly is detected, the main body ECU (multiplex network body ECU) will raise the front passenger side door window to the fully-closed position automatically.

CAUTION / NOTICE / HINT

Note

If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

Click here

PROCEDURE


  1. READ VALUE USING GTS (FR Door Courtesy SW, FL Door Courtesy SW)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      FR Door Courtesy SW Front door courtesy light switch assembly (for RH) signal OFF or ON

      OFF: Front door RH closed

      ON: Front door RH open

      		 *1
      FL Door Courtesy SW Front door courtesy light switch assembly (for LH) signal OFF or ON

      OFF: Front door LH closed

      ON: Front door LH open

      		 *2

      • *1: for LHD

      • *2: for RHD


      Body Electrical > Main Body > Data List
      Tester Display
      FR Door Courtesy SW
      FL Door Courtesy SW
      OK
      On the GTS screen, OFF or ON is displayed accordingly.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO LIGHTING SYSTEM (Door Courtesy Switch Circuit) Click here

    OK

  2. READ VALUE USING GTS (Communication P-Door Motor)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Normal Condition Reference Value Diagnostic Note
      Communication P-Door Motor Connection status between power window regulator motor assembly (for front passenger door) and main body ECU (multiplex network body ECU) STOP or OK

      STOP: Communication stopped

      OK: Normal communication

      		 -

      Body Electrical > Main Body > Data List
      Tester Display
      Communication P-Door Motor
      OK
      On the GTS screen, STOP or OK is displayed accordingly.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO LIN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    OK

  3. PERFORM INITIALIZATION


    1. Initialize the power window regulator motor assembly.

      Click here

    2. Check the power window control system.

      Click here

      OK
      Passenger side door power window operates normally.
      Result
      Proceed to
      OK
      NG

    OK

    END

    NG

    REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY