SIDE AIRBAG SENSOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  4. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  5. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

    Click here

  6. REMOVE REAR SIDE SEATBACK ASSEMBLY

    Click here

  7. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    Click here

  9. REMOVE SIDE AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the connector from the side airbag sensor assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

        B0074GPC18
        *a White Housing Lock *b Yellow CPA
        *c Slide *d Push

      2. Push down the white housing lock again and disconnect the connector.

        Note

        Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. B0074TB

      Remove the bolt and side airbag sensor assembly from the vehicle body.

      Note

      Loosen the bolt while holding the side airbag sensor assembly because the side airbag sensor assembly pin (stopper) is easily damaged.

    5. After disconnecting the connector, check that the position of the white housing lock is as shown in the illustration.

      B0077J7C01
      *a Correct *b Incorrect