SIDE AIRBAG SENSOR(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing.

   Click here

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

   Click here

4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click here

5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

   Click here

6. REMOVE DOOR TRIM COVER

   Click here

7. REMOVE COURTESY LIGHT ASSEMBLY

   Click here

8. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

   Click here

9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

10. REMOVE DOOR SIDE AIRBAG SENSOR

    
    

    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

       CAUTION:

       Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the connector from the door side airbag sensor.

       Note

       When disconnecting any airbag connector, take care not to damage the airbag wire harness.

       
       

       1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

          

          *a	White Housing Lock	*b	Yellow CPA
          *c	Connector lock is released	-	-

       2. Push down the white housing lock again and disconnect the connector.

          Note

          Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. 

       Remove the bolt and door side airbag sensor from the front door panel.

       Note

       Loosen the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.

    5. After disconnecting the connector, check that the position of the white housing lock is as shown in the illustration.

       

       *a

       Incorrect

       *b

       Correct