SPIRAL CABLE REMOVAL

PROCEDURE


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. B0077E0C01
      *A w/o Steering Heater
      *B w/ Steering Heater
      *C Flat Cable Type
      *D Colored Roller Type
      *a Flat Cable
      *b Colored Roller

      Check the colored roller or flat cable shown in the illustration.

      If the colored roller or flat cable shown in the illustration cannot be confirmed, it is possible that the spiral cable with sensor sub-assembly is broken. Replace the spiral cable with sensor sub-assembly with a new one.

  4. REMOVE STEERING COLUMN COVER

    Click here

  5. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

    • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

    • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Check that the front wheels are aligned facing straight ahead.

    4. B0076CNC01
      *a Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. Disconnect the other connectors from the spiral cable with sensor sub-assembly.

    6. B0075GP

      Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.

  6. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Remove the spiral cable sub-assembly from the steering sensor only when replacing it or the steering sensor.

    • Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable sub-assembly when removing the steering sensor from the spiral cable sub-assembly.

    • When replacing the steering sensor:

      Click here


    1. B00772V

      Install the lock pin to the steering sensor.

      Note


      • Use the lock pin provided with a new spiral cable sub-assembly.

      • Do not remove the lock pin before the spiral cable sub-assembly is installed to the steering sensor.

    2. B00740C

      Disengage the 6 claws and 2 pins, and remove the spiral cable sub-assembly from the steering sensor.

      Note

      Do not damage the claws and pins of the spiral cable sub-assembly.