NETWORK GATEWAY ECU REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

Note


  • When disassembling the central gateway ECU (network gateway ECU), eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  2. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for RHD)

    Click here

  4. REMOVE FRONT NO. 2 CONSOLE BOX INSERT (for LHD)

    Click here

  5. REMOVE FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

    Click here

  6. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  7. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  8. REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)


    1. B0076O2

      Disconnect the central gateway ECU (network gateway ECU) connector.

    2. Remove the 2 bolts and central gateway ECU (network gateway ECU) from the blower assembly.