GENERATOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  4. REMOVE V-RIBBED BELT

    Click here

  5. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

    Click here

  6. REMOVE COOLER COMPRESSOR ASSEMBLY

    Click here

  7. REMOVE GENERATOR ASSEMBLY


    1. B0076W8

      Disengage the 2 wire harness clamps.

    2. B00765I

      Remove the terminal cap.

    3. Remove the nut and disconnect the wire harness from terminal B.

    4. Disconnect the generator assembly connector.

    5. B0074N1

      Disengage the clamp and disconnect the wire harness from the generator bracket.

    6. Remove the nut, stud bolt and disconnect the generator bracket.

    7. B0076DQ

      Remove the 2 bolts and generator assembly.

    8. B0072W6

      Remove the bolt and generator bracket from the generator assembly.