GENERATOR COMPONENTS
ILLUSTRATION
| *1 | CENTER NO. 4 ENGINE UNDER COVER | *2 | COOL AIR INTAKE DUCT SEAL |
| *3 | ENGINE ROOM SIDE COVER | *4 | GENERATOR ASSEMBLY |
| *5 | NO. 1 RADIATOR HOSE | *6 | NO. 2 ENGINE COVER SUB-ASSEMBLY |
| *7 | NO. 2 IDLER PULLEY SUB-ASSEMBLY | *8 | NO. 2 IDLER PULLEY COVER PLATE |
| *9 | TERMINAL CAP | *10 | GENERATOR BRACKET |
| *11 | WIRE HARNESS BRACKET | *12 | COOLING FAN ECU CONNECTOR |
| *13 | GENERATOR ASSEMBLY CONNECTOR | *14 | ENGINE WIRE BRACKET |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | GENERATOR BRUSH HOLDER ASSEMBLY | *2 | GENERATOR COIL ASSEMBLY |
| *3 | GENERATOR DRIVE END FRAME BEARING | *4 | GENERATOR PULLEY CAP |
| *5 | GENERATOR PULLEY WITH CLUTCH | *6 | GENERATOR REAR END COVER |
| *7 | GENERATOR ROTOR ASSEMBLY | *8 | GENERATOR TERMINAL INSULATOR |
| *9 | WASHER | *10 | GENERATOR DRIVE END FRAME |
| *11 | RETAINER PLATE | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
| ● | Non-reusable part | - | - |