ULTRASONIC SENSOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE NO. 1 ULTRASONIC SENSOR (for Corner Sensor)


    1. A01VR3Q

      Disconnect the connector.

    2. Disengage the 2 claws and remove the No. 1 ultrasonic sensor.

  3. REMOVE NO. 1 ULTRASONIC SENSOR (for Back Sensor)


    1. A01VTBU

      Disconnect the connector.

    2. Disengage the 2 claws.

    3. Disengage the clamp and remove the No. 1 ultrasonic sensor with clip.

    4. A01VRB3C01
      *a Protective tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor.

  4. REMOVE NO. 3 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this step only when necessary.

    • Use the same procedure for all No. 3 ultrasonic sensor retainers.


    1. A01VSLI

      Remove the No. 3 ultrasonic sensor retainer.