PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function), Diagnostic DTC:C1611

DTC Code DTC Name
C1611 ECU Malfunction

DESCRIPTION

This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check.

Tech Tips

The rear television camera assembly stores different types of information during initialization. If the rear television camera assembly cannot read the stored information when it is activated, the rear television camera assembly judges that there is an internal malfunction and stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1611 ECU Malfunction

When any of the following conditions is met:


  • EEPROM status (Initial read) malfunction

  • CPU communication malfunction

  • Video output malfunction

 Rear television camera assembly

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

PROCEDURE


  1. READ VALUE USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / IPA/Parking Assist Monitor / Data List.

    5. Read the Data List according to the display on the GTS.


      Chassis > IPA/Parking Assist Monitor > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Video Output Status Output condition of video signal OK or NG

      OK: Output condition of video signal is normal

      NG: Output condition of video signal is abnormal

      		 -
      EEPROM Status (Initial read) Rear television camera assembly information OK or NG

      OK: Rear television camera assembly normal

      NG: Rear television camera assembly abnormal

      		 -
      CPU Communication Status Rear television camera assembly information OK or NG

      OK: Rear television camera assembly normal

      NG: Rear television camera assembly abnormal

      		 -

      Chassis > IPA/Parking Assist Monitor > Data List
      Tester Display
      Video Output Status
      EEPROM Status (Initial read)
      CPU Communication Status
      Result
      Result Proceed to
      OK is displayed for all items A
      NG is displayed for EEPROM status (Initial read)
      NG is displayed for items other than EEPROM status (Initial read) B

    B

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here

    A

  2. PERFORM CALIBRATION


    1. Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.


      1. Rear television camera assembly optical axis adjustment (back camera position setting).

        Click here

      2. Steering angle setting.

        Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK DTC OUTPUT


    1. Clear the DTCs.


      Chassis > IPA/Parking Assist Monitor > Clear DTCs

    2. Recheck for DTCs and check that no DTCs are output.


      Chassis > IPA/Parking Assist Monitor > Trouble Codes

      Tech Tips


      • If DTC C1611 is output, perform the procedure to allow the rear television camera assembly to store the vehicle information again.

      • If DTC C1611 is still output after performing the procedure to make the rear television camera assembly store the vehicle information 3 times, replace the rear television camera assembly.

      Result
      Result Proceed to
      DTC C1611 is output A
      DTC C1611 is not output B

    A

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here

    B

    END