PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) Guide Lines are Displayed with Vehicle Center Line

DESCRIPTION

The rear television camera assembly can create parking guide lines. As this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the rear television camera assembly is disabled.

WIRING DIAGRAM

A01VS8LE01

CAUTION / NOTICE / HINT

Note


  • When "System initializing" is displayed on the multi-display after disconnecting and reconnecting the cable to the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

PROCEDURE


  1. CHECK SCREEN MODE


    1. A01VTAPC01
      *a Vehicle Center Line

      Check the parking assist monitor screen.

      Result
      Result Proceed to
      Guide lines are displayed with vehicle center lines A
      Guide lines are displayed without vehicle center lines B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. INSPECT LUGGAGE ELECTRICAL KEY SWITCH


    1. Disconnect the U40 luggage electrical key switch connector.

    2. Disconnect the A rear television camera assembly connector.

    3. Inspect the luggage electrical key switch.

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE LUGGAGE ELECTRICAL KEY SWITCH Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (LUGGAGE ELECTRICAL KEY SWITCH - BODY GROUND)


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      U40-4 (CURT) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR