NAVIGATION RECEIVER REMOVAL

PROCEDURE

1. PRECAUTION

   Click here

   Note

   
   

   • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

     Click here

   • w/ Telematics Transceiver:

     A Hard Disk Drive (HDD) is built into the radio receiver assembly to store music data of sound library function. Therefore, care must be taken for the following points when handling the radio receiver assembly.

   • w/ Telematics Transceiver:

     When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

   Click here

4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

   Click here

5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

   Click here

6. REMOVE FRONT PANEL GARNISH LH

   Click here

7. REMOVE FRONT PANEL GARNISH RH

   Click here

8. REMOVE CONSOLE PANEL SUB-ASSEMBLY

   Click here

9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

   Click here

10. REMOVE NO. 1 RADIO BRACKET

    Click here

11. REMOVE NO. 2 RADIO BRACKET

    Click here

12. REMOVE HARD DISK DRIVE (w/ Telematics Transceiver)

    Click here

13. REMOVE RADIO RECEIVER ASSEMBLY