FRONT BRAKE REASSEMBLY

PROCEDURE


  1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

    Tech Tips

    Fully tighten the front disc brake bleeder plug after bleeding the system.

  2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

  3. INSTALL PISTON SEAL


    1. A01FA21C01
      B0076EM Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the entire circumference of 4 new piston seals.

    2. Install the 4 piston seals to the front disc brake cylinder.

      Note

      Securely install the piston seal to the groove of the front disc brake cylinder.

  4. INSTALL FRONT DISC BRAKE PISTON


    1. A01F8C0C01
      *1 Cylinder Boot
      *2 Front Disc Brake Piston
      B0076EM Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the entire circumference of 4 new cylinder boots.

    2. Install the 4 cylinder boots to the 4 front disc brake pistons.

    3. Apply a light layer of lithium soap base glycol grease to the contact surfaces of the 4 front disc brake pistons, and install them to the front disc brake cylinder.

      Note

      Do not forcibly install the front disc brake piston into the front disc brake cylinder.

  5. INSTALL CYLINDER BOOT


    1. A01F7ZFC02
      *1 Cylinder Boot
      *2 Front Disc Brake Cylinder
      *3 Front Disc Brake Piston

      Install the 4 cylinder boots to the front disc brake cylinder.

      Note


      • Make sure that the cylinder boot is securely installed into the groove of the front disc brake cylinder and front disc brake piston.

      • Do not damage the cylinder boots.