VACUUM PUMP(for 2GR-FKS) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE BATTERY (for LHD)

    Click here

  4. SEPARATE NO. 2 ENGINE WIRE (for LHD)


    1. B0077SS

      Remove the bolt and separate the No. 2 engine wire.

  5. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

    Click here

  6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

    Click here

  7. DISCONNECT VACUUM HOSE ASSEMBLY (for LHD)

    Click here

  8. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  9. DISCONNECT INLET HEATER WATER HOSE A

    Click here

  10. DISCONNECT OUTLET HEATER WATER HOSE A

    Click here

  11. DISCONNECT UNION TO CONNECTOR TUBE HOSE (for RHD)


    1. B0076KA

      Slide the clip and disconnect the union to connector tube hose from the vacuum pump assembly.

  12. DISCONNECT NO. 12 WATER BY-PASS HOSE


    1. B0077X1

      Slide the clip and disconnect the No. 12 water by-pass hose from the No. 2 water by-pass pipe.

  13. SEPARATE NO. 2 WATER BY-PASS PIPE


    1. B00756D

      Remove the bolt and separate the No. 2 water by-pass pipe.

  14. REMOVE VACUUM PUMP ASSEMBLY


    1. B007722

      Remove the 3 bolts and vacuum pump assembly from the engine assembly.

    2. B0074GTC03
      *1 No. 2 O-ring
      *2 No. 3 O-ring

      Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly.