BRAKE BOOSTER(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL VACUUM SENSOR ASSEMBLY (w/ Stop and Start System)


    1. Install a new check valve grommet to the brake booster assembly.

    2. B0075PYC02
      *a 45° +/- 20°
      B0077IM Up

      Install the vacuum sensor assembly to the brake booster assembly as shown in the illustration.

  2. INSTALL VACUUM WARNING SWITCH ASSEMBLY (w/o Stop and Start System)


    1. Install a new check valve grommet to the brake booster assembly.

    2. B0075QKC01
      *a 45° +/- 20°
      B0077IM Up

      Install the vacuum warning switch assembly to the brake booster assembly as shown in the illustration.

  3. INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY


    1. Install a new check valve grommet to the brake booster assembly.

    2. Install the brake vacuum check valve assembly to the brake booster assembly.

  4. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS


    1. Temporarily install the clevis lock nut and brake master cylinder push rod clevis to the brake booster assembly.

      Note

      Fully tighten the clevis lock nut when adjusting the brake pedal height.

  5. INSTALL BRAKE BOOSTER GASKET


    1. Install a new brake booster gasket to the brake booster assembly.

  6. INSTALL BRAKE BOOSTER ASSEMBLY


    1. Install the brake booster assembly to the vehicle body with the 4 nuts.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

      Note

      Do not kink or damage the brake lines.

    2. w/ Stop and Start System:


      1. Connect the connector to the vacuum sensor assembly.

    3. w/o Stop and Start System:


      1. Connect the connector to the vacuum warning switch assembly.

  7. INSTALL PUSH ROD PIN

    Click here

  8. INSTALL BRAKE PEDAL RETURN SPRING


    1. Install the brake pedal return spring to the push rod pin and steering column assembly.

  9. INSTALL BRAKE ACTUATOR WITH BRACKET

    Click here

  10. INSTALL REAR NO. 1 BRAKE TUBE

    Click here

  11. INSTALL FRONT NO. 1 BRAKE TUBE

    Click here

  12. CONNECT UNION TO CHECK VALVE HOSE

    Click here

  13. INSTALL FRONT NO. 2 BRAKE TUBE

    Click here

  14. INSTALL BRAKE MASTER CYLINDER O-RING

    Click here

  15. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  16. INSTALL WIRING HARNESS CLAMP BRACKET

    Click here

  17. INSTALL NO. 3 ENGINE ROOM RELAY BLOCK ASSEMBLY

    Click here

  18. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD.

    Click here

  19. BLEED BRAKE SYSTEM

    Click here

  20. INSTALL FRONT WHEEL RH

    Click here

  21. INSPECT AND ADJUST BRAKE PEDAL

    Click here