YAW RATE AND ACCELERATION SENSOR INSTALLATION

PROCEDURE

1. INSTALL YAW RATE SENSOR BRACKET

   
   

   1. Engage the 2 claws and install the yaw rate sensor bracket.

      Tech Tips

      Install the yaw rate sensor bracket while avoiding the wire harness.

   2. Install the 3 bolts.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

   3. Engage the 2 wire harness clamps to the yaw rate sensor bracket.

2. INSTALL YAW RATE SENSOR

   
   

   1. Install the yaw rate sensor with the 2 nuts.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      
      

      • Do not drop the yaw rate sensor.

      • If the yaw rate sensor is dropped, replace it with a new one.

   2. Connect the connector to the yaw rate sensor.

      Note

      Make sure that the yaw rate sensor connector is connected securely.

   3. Engage the wire harness clamp to the yaw rate sensor bracket.

3. INSTALL NO. 1 CONSOLE BOX DUCT

   Click here

4. INSTALL CONSOLE BOX ASSEMBLY

   Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

6. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION AND STORE SYSTEM INFORMATION

   Click here