REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • The rear speed sensor rotor is a component of the rear axle hub and bearing assembly. If the rear speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER

    Click here

  4. REMOVE SPARE WHEEL COVER TRAY

    Click here

  5. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER

    Click here

  6. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  7. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  8. REMOVE FRONT UPPER LUGGAGE COMPARTMENT TRIM COVER

    Click here

  9. SEPARATE LUGGAGE COMPARTMENT TRIM COVER LH (for LH Side)


    1. B00751B

      Disengage the 4 claws and open the 2 covers.

    2. B00741W

      Remove the 2 bolts and 2 rope hook assemblies.

    3. B0072ZV

      Remove the 4 clips.

    4. Disengage the claw.

    5. Separate the luggage compartment trim cover LH from the vehicle body.

  10. SEPARATE LUGGAGE COMPARTMENT TRIM COVER RH (for RH Side)


    1. B0073QU

      Disengage the 4 claws and open the 2 covers.

    2. B00734C

      Remove the 2 bolts and 2 rope hook assemblies.

    3. w/o Deck Side Trim Box:


      1. B0076WU

        Remove the 4 clips.

      2. Disengage the claw.

      3. Separate the luggage compartment trim cover RH from the vehicle body.

    4. w/ Deck Side Trim Box:


      1. B0074KR

        Disengage the clip and 5 guides and remove the deck side trim box RH.

      2. B0073MP

        Remove the 4 clips.

      3. Disengage the claw.

      4. Separate the luggage compartment trim cover RH from the vehicle body.

  11. REMOVE REAR WHEEL

    Click here

  12. SEPARATE REAR WHEEL HOUSE LINER


    1. B0073OL

      Remove the 2 nuts and separate the rear wheel house liner.

  13. REMOVE REAR SPEED SENSOR


    1. Turn back the luggage compartment trim cover until the rear speed sensor connector can be seen.

    2. Disengage the rear speed sensor connector.

      B0074TCC01
      *A for LH Side *B for RH Side
    3. B0076O3

      Remove the 3 bolts and separate the rear speed sensor and 2 sensor clamps from the rear axle carrier sub-assembly and rear upper control arm assembly.

      Note


      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.

    4. Turn back the rear wheel house liner until the grommet can be disengaged.

    5. B0075BO

      Remove the 2 nuts and 2 sensor clamps.

    6. Disengage the grommet and remove the rear speed sensor.