ABSORBER CONTROL ACTUATOR(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE UPPER SHOCK ABSORBER CAP


    1. B00778Q

      Remove the 3 nuts and separate the upper shock absorber cap.

    2. Disconnect the connector.

    3. Separate the wire harness and remove the upper shock absorber cap.

  4. REMOVE ABSORBER CONTROL ACTUATOR


    1. B007557C02
      *a 40°

      Turn the absorber control actuator 40° counterclockwise to remove it from the front actuator support bracket.

      Note


      • Do not turn the absorber control actuator more than 40°.

      • Do not drop the absorber control actuator. If it is dropped, replace it with a new one.