REAR DIFFERENTIAL CARRIER ASSEMBLY(for 2GR-FSE) COMPONENTS
ILLUSTRATION
| *1 | TAIL EXHAUST PIPE ASSEMBLY | *2 | TAIL EXHAUST PIPE LH |
ILLUSTRATION
| *1 | REAR DIFFERENTIAL CARRIER ASSEMBLY | *2 | REAR UPPER DIFFERENTIAL MOUNT STOPPER |
| *3 | REAR LOWER DIFFERENTIAL MOUNT STOPPER | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
| ● | Non-reusable part |  |
Do not apply lubricants |
| *T1 | Bolt Type A: 95.1 N*m (970 kgf*cm, 70 ft.*lbf) Bolt Type B: 88.9 N*m (907 kgf*cm, 66 ft.*lbf) |
- | - |
ILLUSTRATION
| *1 | REAR DIFFERENTIAL BREATHER PLUG | *2 | REAR DIFFERENTIAL BREATHER PLUG OIL DEFLECTOR |
| *3 | REAR DIFFERENTIAL CARRIER COVER | *4 | REAR DIFFERENTIAL CARRIER OIL SEAL |
| *5 | REAR DIFFERENTIAL CARRIER STRAIGHT PIN | *6 | REAR DIFFERENTIAL DRAIN PLUG |
| *7 | REAR DIFFERENTIAL DRIVE PINION BEARING SPACER | *8 | REAR DIFFERENTIAL DRIVE PINION OIL SLINGER |
| *9 | REAR DIFFERENTIAL DUST DEFLECTOR | *10 | REAR DIFFERENTIAL SIDE GEAR SHAFT SNAP RING |
| *11 | REAR DRIVE PINION COMPANION FLANGE | *12 | REAR DRIVE PINION FRONT TAPERED ROLLER BEARING |
| *13 | REAR DRIVE PINION NUT | *14 | REAR DRIVE SHAFT OIL SEAL |
| *15 | REAR DIFFERENTIAL FILLER PLUG | *16 | GASKET |
| *17 | REAR DIFFERENTIAL CARRIER | - | - |
| *T1 | Preload Adjust Torque: 490 N*m (4997 kgf*cm, 361 ft.*lbf) or less | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Hypoid gear oil LSD | - | - |
ILLUSTRATION
| *1 | DIFFERENTIAL DRIVE PINION | *2 | DIFFERENTIAL RING GEAR |
| *3 | REAR DIFFERENTIAL CASE BEARING | *4 | REAR DIFFERENTIAL CASE SUB-ASSEMBLY |
| *5 | REAR DRIVE PINION REAR TAPERED ROLLER BEARING | *6 | REAR DIFFERENTIAL DRIVE PINION PLATE WASHER |
| *7 | REAR DIFFERENTIAL CASE BOLT | - | - |
| *T1 | 1st: 63.7 N*m (650 kgf*cm, 47 ft.*lbf) 2nd: 60° to 90° |
- | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Hypoid gear oil LSD | ★ | Precoated Part |