COMBINATION SWITCH INSPECTION

PROCEDURE


  1. INSPECT COMBINATION SWITCH ASSEMBLY


    1. Inspect ECO drive mode switch:


      1. B0075CDC08
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        11 (ECO) - 16 (E) Combination switch turned and held at ECO position Below 50 Ω
        Combination switch not turned 1 MΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    2. Inspect NORMAL mode switch:


      1. B0075CDC09
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        9 (NORM) - 16 (E) Combination switch pushed and held Below 50 Ω
        Combination switch not pushed 1 MΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    3. Inspect the SPORT or SPORT S/S+ mode switch:


      1. B0075CDC10
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        10 (PWR) - 16 (E) Combination switch turned and held at SPORT or SPORT S/S+ position Below 50 Ω
        Combination switch not turned 1 MΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    4. Inspect SNOW mode switch:


      1. B0075CDC11
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 (SNSW) - 16 (E) SNOW mode switch pushed and held Below 50 Ω
        SNOW mode switch not pushed 1 MΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    5. Inspect VSC off mode switch:


      1. B0075CDC12
        *a

        Component without harness connected

        (Combination Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (+) - 16 (E) VSC OFF mode switch pushed and held Below 50 Ω
        VSC OFF mode switch not pushed 1 MΩ or higher

        If the result is not as specified, replace the combination switch assembly.

    6. Inspect illumination:


      1. B0075DSC02
        *A w/ Snow Mode Switch
        *B w/o Snow Mode Switch
        *a

        Component without harness connected

        (Combination Switch Assembly)
        *b Combination Switch Assembly Illumination

        Apply battery voltage between the terminals of the switch, and check the illumination condition of the combination switch assembly.

        Standard
        Measurement Condition Specified Condition
        Battery positive (+) → 5 (ILL+) Battery negative (-) → 8 (ILL-) Illuminates

        If the result is not as specified, replace the combination switch assembly.