SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY


    1. B0074D3N01

      Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.

      Note

      Do not pinch the wire harness.

    2. Fully tighten the 4 bolts in the order shown in the illustration to install the transmission floor shift assembly.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

    3. Connect the transmission control switch connector.

      Note

      Be sure to securely connect the transmission control switch connector.

    4. Engage the 4 clamps to connect the wire harness to the transmission floor shift assembly.

    5. Connect the shift lock control ECU connector.

      Note

      Be sure to securely connect the shift lock control ECU connector.

  2. INSTALL NO. 1 CONSOLE BOX DUCT


    1. Install the No. 1 console box duct with the 2 clips.

    2. Engage the clamp to connect the wire harness to the No. 1 console box duct.

  3. INSTALL CONSOLE BOX ASSEMBLY

    Click here

  4. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. B0074HWC01
      *1 Transmission Control Shaft Lever RH
      *a P
      *b R
      *c N

      Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.

    2. Move the shift lever to N.

    3. B0072Y2C01
      *a Lever
      B0077IM Pushing the lever rearward

      Connect the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly.

    4. Temporarily install the nut to the lever of the transmission floor shift assembly.

    5. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly toward the rear of the vehicle.

      Torque:
      12.8 N*m  { 131 kgf*cm, 9 ft.*lbf }

      Note

      Do not push the lever of the transmission floor shift assembly too hard.

  5. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

    Click here

  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)


  7. INSTALL SHIFT LEVER CAP


    1. B00771DC01
      *a Groove

      Engage the 2 claws to install the shift lever cap to the shift position indicator.

      Note

      Install the shift lock release button cover with its groove facing the rear of the vehicle.

  8. INSPECT SHIFT LEVER POSITION

    Click here

  9. INSPECT FOR EXHAUST GAS LEAK