PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tech Tips

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.


    1. Clean the bolt and bolt hole.

    2. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    3. Temporarily install the park/neutral position switch assembly to the automatic transmission assembly with the bolt.

      Tech Tips

      Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.

    4. Install a new lock washer and the lock nut to the park/neutral position switch assembly.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

    5. Temporarily install the transmission control shaft lever RH to the manual valve lever shaft with the spring washer and nut.

      Tech Tips

      Tighten the nut to the specified torque when adjusting the park/neutral position switch assembly.

    6. A01F9VTC01
      *1 Transmission Control Shaft Lever RH
      *a P
      *b R
      *c N

      Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.

    7. Remove the nut, spring washer and transmission control shaft lever RH from the manual valve lever shaft.

    8. A01FBERC04
      *a Neutral Basic Line
      *b Groove

      Align the neutral basic line with the groove as shown in the illustration.

    9. Hold the park/neutral position switch assembly in that position and tighten the bolt.

      Torque:
      12.8 N*m  { 131 kgf*cm, 9 ft.*lbf }

    10. Using a screwdriver, bend down the tabs of the lock washer.

      Tech Tips

      Bend at least 2 of the lock washer tabs.

    11. Install the transmission control shaft lever RH to the manual valve lever shaft with the spring washer and nut.

      Torque:
      15.7 N*m  { 160 kgf*cm, 12 ft.*lbf }

    12. Connect the park/neutral position switch assembly connector.

  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. A01FB9U

      Connect the floor shift gear shifting rod sub-assembly to the transmission control shaft lever RH with the pin.

    2. Install a new clip.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION

    Click here