DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A06

DTC Code DTC Name
C1A06 Stop Light Switch Input Circuit

DESCRIPTION

If an internal failure (stop light switch assembly input circuit) in the driving support ECU assembly occurs, DTC C1A06 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A06 Stop Light Switch Input Circuit When the engine switch is on (IG), the driving support ECU assembly detects an internal malfunction (stop light switch assembly input circuit malfunction) for approximately 0.2 seconds. Driving support ECU assembly

CAUTION / NOTICE / HINT

Note

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

PROCEDURE


  1. CHECK FOR DTCs


    1. Clear the DTCs.


      Powertrain > Radar Cruise > Clear DTCs

    2. Perform the following to make sure that the DTC detection conditions are met.

      Tech Tips

      If the following conditions are not met, the system cannot detect the malfunction.


      1. Turn the engine switch on (IG).

      2. Wait for 1 second or more.

    3. Check for DTCs.


      Powertrain > Radar Cruise > Trouble Codes
      Result
      Result Proceed to
      DTC C1A06 is not output A
      DTC C1A06 is output B

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    REPLACE DRIVING SUPPORT ECU ASSEMBLY Click here