OIL PUMP COMPONENTS
ILLUSTRATION
| *1 | CYLINDER HEAD COVER SUB-ASSEMBLY | *2 | ENGINE OIL LEVEL DIPSTICK GUIDE |
| *3 | ENGINE WIRE | *4 | IGNITION COIL ASSEMBLY |
| *5 | NO. 1 TURBO WATER PIPE | *6 | NO. 3 VENTILATION HOSE |
| *7 | NO. 3 TURBO WATER BY-PASS HOSE | *8 | NO. 4 VENTILATION HOSE |
| *9 | NO. 4 TURBO WATER BY-PASS HOSE | *10 | NO. 1 VENTILATION HOSE |
| *11 | ENGINE OIL LEVEL DIPSTICK | *12 | O-RING |
| *13 | GASKET | *14 | CAMSHAFT POSITION SENSOR (for Intake Side) |
| *15 | SUCTION HOSE | *16 | CYLINDER HEAD COVER GASKET |
| *17 | NO. 2 CYLINDER HEAD COVER GASKET | *18 | CAMSHAFT POSITION SENSOR (for Exhaust Side) |
| *19 | CAMSHAFT BEARING CAP OIL HOLE GASKET | *20 | ENGINE ROOM ECU COVER |
| *21 | NO. 1 TURBO WATER BY-PASS HOSE | *22 | NO. 2 TURBO WATER BY-PASS HOSE |
| *23 | SUCTION PIPE SUB-ASSEMBLY | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Compressor oil ND-OIL 8 or equivalent | - | - |
ILLUSTRATION
| *1 | AIR CLEANER BRACKET | *2 | CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY |
| *3 | CRANKSHAFT POSITION SENSOR | *4 | CRANKSHAFT PULLEY ASSEMBLY |
| *5 | IDLER PULLEY SUB-ASSEMBLY | *6 | TIMING CHAIN COVER ASSEMBLY |
| *7 | TIMING CHAIN COVER OIL SEAL | *8 | V-RIBBED BELT TENSIONER ASSEMBLY |
| *9 | WATER OUTLET SUB-ASSEMBLY | *10 | CRANKSHAFT PULLEY SET BOLT |
| *11 | O-RING | *12 | GASKET |
| *13 | NO. 6 WATER BY-PASS HOSE | *14 | OIL PUMP GASKET |
| *15 | NO. 2 OIL STRAINER GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
MP Grease |  |
Adhesive 1324 |
| ★ | Precoated part |  |
Do not apply lubricants to the threaded parts |