ENGINE OIL TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL TEMPERATURE SENSOR


    1. Install a new gasket to the engine oil temperature sensor.

    2. A01VSYIC01
      *a Torque Wrench Fulcrum Length

      Using a 19 mm union nut wrench, install the engine oil temperature sensor to the stiffening crankcase assembly.

      Torque:
      Specified tightening torque
      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      If the engine oil temperature sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 19 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 16.8 N*m (171 kgf*cm, 12 ft.*lbf)

    3. Connect the engine oil temperature sensor connector.

  2. ADD ENGINE OIL

    Click here

  3. CHECK ENGINE OIL LEVEL

    Click here

  4. INSPECT FOR ENGINE OIL LEAK

    Click here

  5. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)

    Click here

  6. INSTALL FRONT SUSPENSION MEMBER BRACE

    Click here