OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. B007548C10
      *a Adhesive 1344
      *b Oil Inlet Port

      Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note


      • Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

      • Install the oil pressure sender gauge assembly within 3 minutes of applying adhesive.

    2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    3. Connect the oil pressure sender gauge assembly connector.

  2. CONNECT NO. 4 VENTILATION HOSE


    1. A01R6M8C03
      *a Up
      *b 90°

      Connect the No. 4 ventilation hose to the inlet compressor elbow and slide the clip to secure it.

      Tech Tips

      Engage the clip within the area shown in the illustration.

  3. INSPECT FOR OIL LEAK

    Click here